Alternative Environmental Management in The Split Making Industry

J Purwanta, Suharwanto Suharwanto, Trismi Ristyowati

Abstract


The purpose of this study is to carry out environmental management in the split-making industry, especially on the spread of dust. In the field of building construction, at the stage of casting activities, various construction materials are needed, such as cement, sand, water, iron, and splits. The existence of a split will further increase the strength of the cast. Therefore, splits are indispensable in the field of construction. The raw material for the split is andesite stone. In the split production process using a stone crusher called a stone crusher. In the operation of this stone crusher, the dust appears generated from andesite stone flakes which are being reduced in size to split. The dust will spread to the surrounding environment because it is carried away by the wind. This condition will cause a negative impact, namely a decrease in air quality. Therefore, steps/actions should be taken to minimize the spread of dust, namely by capturing the dust that comes out of the stone crusher tool carried by the exhaust gas flow. The equipment used in this research is a laboratory-scale using a fogging method dust catcher. The sprayer hole diameter is the independent variable, while the other quantities are the dependent variable. The research was conducted on the nozzle diameter as much as 5 quantities and carried out 3 replications for each quantity, then averaged the results. After the research was carried out, the data obtained from the research showed that the optimum condition for the mass of dust that was caught by the fog was the diameter of the sprayer hole 1, 45 mm with an average dust mass that can be caught by the fog is 14,068.33 µg and average efficiency value of 72.67%. The line equation which states the relationship between the variable sprayer hole diameter and the mass of dust caught by the fog is Y = -14.722.X3 - 782.86 X2 + 4978.5X +6265.7 with a percent error of 1.53%, while the line equation states the relationship between diameter nozzle with an efficiency value that is Y = 0.1042X3 - 5.3775X2 + 28.608X + 30.564 with an average percent error of 2.37%.


Keywords


Spread, control, stone crusher, dust, fog

Full Text:

PDF

References


Abishek, P.S. and Ramachandran, P.N., 2015, "Design of pleated bag filter system for particulate emission control in cement industry", International Research Journal of Engineering and Technology (IRJET), Volume 02 Issue 05, India.

Fityatur, R., 2015, “Dampak Sosial-Ekonomi Pabrik Semen Puger Di Kecamatan Puger Kabupaten Jember”, Jember.

Khattak, Z., Ahmad, J., Ali, H.M., and Shah, S., 2013, “Contemporary dust control techniques in cement industry, Electrostatic Precipitator - a case study”, World Applied Sciences Journal 22 (2) pp.202-209, Pakistan.

Otaru, A.J., Odigure, J.O., Okafor, J.O., and Abdulkareem, A.S., 2013, Investigation into particulate pollutant concentration from a cement plant: a case study of Obajana Cement Plc, Lokoja, Nigeria, IQSR Journal of Environmental Science, Toxicology, and Food Technology (IQSR-JESTFT), Volume 3, Issue 2, pp.89-96, Nigeria.

Thaib, Y.P. dkk, 2014, Hubungan Antara Paparan Debu Dengan Kejadian Gangguan Saluran Pernafasan Pada Masyarakat Kelurahan Kairagi Satu Lingkungan 3 Kota Manado, Universitas Sam Ratulangi, Manado.




DOI: https://doi.org/10.31098/ess.v1i1.89

Article Metrics

Abstract view : 26 times
PDF - 15 times

Refbacks

  • There are currently no refbacks.


Copyright (c) 2020 J Purwanta, Suharwanto Suharwanto, Trismi Ristyowati

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

PUBLISHED BY:

LPPM UPN “Veteran” Yogyakarta, RSF PRESS & RESEARCH SYNERGY FOUNDATION

Proceeding of LPPM UPN “Veteran” Yogyakarta Conference Series 2020 – Engineering and Science (ESS). 

Mailing Address: 
Research Synergy Foundation
Jalan Nyaman no 31 
Komplek Sinergi Antapani 
Bandung 40291 - Indonesia. 

Gedung Rektorat Lt. 3 
Universitas Pembangunan Nasional "VETERAN" Yogyakarta 
Jl. SWK 104 (Lingkar Utara)
Condong Catur
Yogyakarta 55283 - Indonesia. 

Email:info@upnconfeseries.com

 
The Proceeding of LPPM UPN “Veteran” Yogyakarta Conference Series 2020 – Engineering and Science (ESS) is indexed by:
 
  
 
 
Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.